After switching the RAID mode on the D2-320, the indicator light turns yellow. How can I confirm the settings are correct?

Applicable Models

D2-320

When switching RAID modes, ensure the device is powered on and connected to the computer. Follow these steps:

1. Use a screwdriver to toggle the switch to the target RAID mode.
2. Use a pin to press and hold the Reset button for 5 seconds; the indicator will change from green to red.
3. After about 1 second, the indicator will turn green again, indicating that the setup is complete.

With two 1TB hard drives as an example, the display in Windows Disk Management will be as follows:
Single (SINGLE): Two independent 1TB disks
RAID 1: A single 1TB mirrored disk
RAID 0: A single 2TB combined disk
JBOD: A single 2TB concatenated disk